JRT192 AJ51A Jenn-Air Refrigerator Parts List

Kickplate clip

This kickplate clip is an inch long and is made of metal. Two are needed per refrigerator.

Evaporator fan motor - 115v 60hz - blade not included (evaporator fan motor)

The evaporator fan motor circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. This part is 115 volts, has a 3/16th-inch shaft and is just over three inches long. It is made of both metal and plastic, and is made up of black, white, and metallic pieces. This evaporator fan motor is a genuine OEM part. Please remember to disconnect the power to your appliance before starting the repair.

Compression nut

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

6-hour defrost timer (sub 66128-1)

This part may appear different than the original, but will function the same. This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

Cold control thermostat (sub 68601-6)

This cold control thermostat has a temperature range from 37 degrees Fahrenheit to 27 degrees Fahrenheit and a capillary length of 29 iches. This cold control thermostat cycles on and off regularly to keep your refrigerator cold.

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Egg tray (sub 60066-1)

This egg tray holds fourteen eggs.

Food door gasket (measures 30-3/4" by 39') (sub 70048-3)

This white fresh food door gasket measures approximately 30-3/4 inches by 39 inches. It is used on many fresh food doors of top mount model refrigerators that have been manufactured since 1980.

Plastic tubing

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Ice maker front cover (cover ice maker)

Screw

Sold individually.

Leveler

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Defrost heater

This radiant glass defrost heater is twenty and a half inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators.

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Defrost evaporator pan

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.